FRP solid rods and flat bars for fabricated components. Find a catalogue section, check its dimensions, then send your cut lengths, tolerances and quantities for quotation review.
Supplied MACHS archive photograph of solid round rods. Flat bars are a separate section option; confirm the approved drawing, dimensions, material and finish. Colours do not identify a resin or performance grade.← Pultruded profiles
Specification notes
Section
Solid rods and flat bars
Dimensions
Diameter or section width / thickness, length and tolerances
Fabrication
Cutting and drilling reviewed against drawing
Parameter source: P019 / V9 2026-11-05 / V8 R3. Only the listed configuration is described. Missing dimensions, mass and working loads are not estimated.
Choose the dimensions that describe a solid section
For round rods, provide diameter and length. For flat bars, provide width, thickness and length. Identify straightness, surface or dimensional tolerances that affect the assembly rather than assuming all catalogue sections have the same limits.
Define the finished part
Provide the resin or service exposure, quantity, cut lengths, holes, machining details and mating parts. Tooling availability and structural suitability are reviewed against the actual section and use, not inferred from this family entry.
Specify the section rather than its appearance
Provide a section drawing with the dimension convention, length, tolerances and revision. For a hollow tube, identify outside dimensions and wall thickness; for a solid rod or bar, identify the diameter or solid width and thickness. For an open structural section, identify web, flange and leg dimensions separately.
Review loads, holes and connection zones
State the intended use, support and connection arrangement, load direction and any concentrated forces around holes or inserts. Pultruded composite sections require configuration-specific design review; a similar steel-section name does not establish equivalent stiffness, strength or fastening details.
Define fabrication and acceptance
Show cut lengths, hole sizes and positions, edge distances, orientation, finish and identification in the drawing package. Agree which fabrication operations and dimensional checks are included. Keep the approved drawing revision with the purchasing and inspection records so a later repeat order refers to the same configuration.
Application and assembly conditions
For solid rods and flat bars used as fabricated components, identify the mating parts, cut lengths, holes and service exposure. State whether stiffness, strength, insulation or another property is required and name the test or acceptance requirement. These are part-selection inputs, not verified performance claims for every section.
Swipe or scroll the table horizontally to read all columns on a small screen.
Recorded specification — FRP rods & flat bars
Specification item
Recorded value
Section
Solid rods and flat bars
Dimensions
Diameter or section width / thickness, length and tolerances
Fabrication
Cutting and drilling reviewed against drawing
Is a section photograph enough to place a repeat order?
No. Use the approved section drawing, revision, material and finish specification, length, fabrication details and acceptance criteria. A family photograph does not identify the supplied resin or dimensional tolerances.
Files and media
Pultruded flat bars — supplied archive photograph
MACHS supplied archive I0537. Flat-bar family photograph only; pictured holes, sizes, colours and materials are not an approved order specification. Confirm the finished drawing and revision.
66 source-coded geometry references. These are historical catalogue entries, not a current stock list or blanket certification. Open the exact code for dimensions, evidence limits, comparison and enquiry.